TECHNOLOGY | 7 MIN TO READ
Comparison of 4 blade-based ice detection systems
Whitepaper: Optimise your wind turbine by using ice detection
Cost efficiency, high yields and turbine safety are the most important factors in the operation of wind turbines. Ice detection systems provide support to ensure efficient operation of wind turbines even in the windiest winter months.
As part of a project (Meteotest (2021), Comparison of four detection systems of rotor icing installed on the same turbine, VGB Research Foundation, Project 401), a comprehensive field test was conducted from 2016-2020 in Stor-Rotliden, Sweden. The aim was to install all four established blade-based ice detection systems (IDS) from Polytech (former fos4x), Wölfel, Weidmüller and eologix on the same Vestas V-90 and comparing them over many icing events (none of the four IDS controls the WT during the field test).
Efficient operation of wind turbines under icing conditions requires accurate detection of icing, both in terms of timing and severity. The four different IDS detect rotor icing from the inside or outside of the rotor blades:
- The IDS from Polytech (former fos4X), Wölfel and Weidmüller detect rotor icing based on changes in the frequency spectrum of the blade vibrations – these are also referred to vibration-based ice detection systems (VBS)
- The eologix system detects rotor icing based on the electrical impedance directly on the rotor blade surface
Overview of the compared ice detection systems
eologix – www.eologix.com
eologix offers (retrofittable) sensor systems for early and exact ice detection based on the electrical impedance directly on the rotor blade surface. The sensors are wireless, flexible, smart and energy-self-sufficient and installed directly on the surface of rotor blades.
Polytech (ehemals fos4x) – www.polytech.com
The system measures and learns the natural frequencies of the rotor blades under various operating conditions. As soon as ice masses form on the blades, the vibration behavior of the rotor blades changes. Measuring accuracy of less than 9 mm or less than 10 kg per blade.
Weidmüller – www.weidmueller.de
BLADEcontrol® measures the degree of icing directly on the rotor blades and is based on a simple physical principle: The ice accumulation changes the natural vibration behavior of the rotor blade due to its additional weight, which reduces the vibration frequency.
Wölfel – www.woelfel.de
IDD.Blade measures the vibration behavior with sensors inside the rotor blades. If the mass of a rotor blade changes due to ice accumulation, the vibration behavior also changes.
Read more about the differences between rotor blade-based ice detection systems in our Whitepaper Ice Detection.
A detailed comparison of four blade-based IDS
After four winter seasons a data set of approximately 5700 operating hours (simultaneous operation of all four systems) of the wind turbines was collected, with approximately 2500 hours of icing (only rime ice). Several cameras have been used as a reference. This unique dataset allows a detailed comparison of the four blade-based IDS.
The analysis of the icing events showed that there is a consistensy between all four IDS and the camera images in terms of the timing of the icing events. The number of icing events for the three vibration-based IDS is very similar. However, differences in the total duration of turbine stops could be observed due to different sensitivity of the systems. Concerning the eologix system, there were significantly fewer and shorter downtimes.
The four blade-based ice detection systems compared using the example of an ice event from this study
The following figure shows an example of an ice event from this study. As can be seen in the figure, the eologix sensor system is the first to detect ice (turquoise – showing the eologix sensors), whereas the vibration-based ice detection systems (IDS1, IDS2 and IDS3) detect ice much later (visible in red).
The eologix system is the last system to shut down the plant, as it can distinguish between safety-relevant icing and non-safety-relevant icing (shown in red in the eologix line above| compared to IDS1, IDS2 and IDS3).
Example of an ice event (VGB research project 401; Abstract presented at Winterwind 2021) – (Source: Comparison of four blade-based ice detection systems installed on the same turbine, Paul Froidevaux, Meteotest AG, Winterwind 2021, April 20, 2021)
eologix compared to other ice detection systems
“[…] most sensitive ice detection status from all four systems.”
(Quote about the eologix system (Meteotest (2021), Comparison of four detection systems of rotor icing installed on the same turbine, VGB Research Foundation, project 401)
Regarding the eologix ice detection system the following points were summarized as results:
- eologix is the first system to detect icing on the rotor blade,
- the eologix system requires the shortest downtimes (if the wind turbine stops according to the system certifications),
- the eologix system stopped the wind turbine 2.5 times shorter than the three VBS,
- eologix was the only system with 100% availability of ice detection during production hours.
It was further noted, unlike the eologix system, the three vibration-based systems could not detect icing at low wind speeds or in the case of standstill.
Related articles
Imbalances on wind turbines: causes, effects and solutions
To ensure efficient and reliable power generation by wind turbines, they must be regularly maintained and inspected to detect and correct potential problems such as imbalances. Basically, there are two types of imbalances that can occur in wind turbines: mass imbalance and aerodynamic imbalance
eologix:align results reflect the ground-based measurements
Viele Windenergieanlagen haben mit aerodynamisch bedingten und/oder massenbedingten Unwuchten zu kämpfen. Die daraus resultierende Gesamtunwucht führt in der Regel zu erhöhten Bauteilschwingungen und kann auf Dauer erhebliche Folgeschäden und hohe Kosten verursachen. Um eine resultierende Gesamtunwucht effektiv zu reduzieren, ist es notwendig, zunächst die aerodynamische Unwucht zu ermitteln und zu verringern. Ein erster und wichtiger Schritt dazu ist es, die relativen Pitchwinkel-Abweichungen zwischen den Blättern während des Betriebs zu erfassen und daraus konkrete Korrekturanweisungen zu erhalten.
4 blade-based ice detection systems tested on one Vestas V-90
Cost efficiency, high yields and system safety are the most important factors in the operation of wind turbines. To ensure efficient operation of wind turbines even in the windiest winter months, accurate detection of icing is required.
Hoarfrost, rime ice and glaze ice in wind turbine operation
Hoarfrost is a form of fog-frost deposition, usually thin, fragile ice needles or scales that adhere only loosely to objects and are formed almost exclusively by sublimation. The prerequisites for the formation of frost are high humidity (around 90 % or more), weak wind and temperature values generally below minus 8 °C.
Safe through the winter: Ice throw and ice fall on wind turbines
How to ensure safety during icing conditions (especially with regard to ice fall and ice throw) – Ice accumulation on wind turbine rotor blades has a crucial impact on operation and maintenance. Lower return due to aerodynamic imbalances as well as safety of the power plant and its surroundings are of central importance.
Regardless of whether a wind turbine is located next to a highway or in the mountains where skiers and hikers pass by – It should be always ensured that service technicians and any trespasser are safe in any turbine operation mode.
France: Updated safety regulations for wind farm operations
Modified safety regulations of wind farm operations in France (in force since January 1, 2021) Click here to the French version of this article On June 22, 2020 a new decree was published by the French Government, to bring some modifications in the safety regulations of wind farm operations (ICPE regulation). Before the modifications…